mudtoy67
12-31-2008, 08:12 PM
It's about time I got a heavy duty table for welding and cutting...the old black and decker folding table is getting a bit worse for wear. So today I set out to find materials to build one, but stumbled upon this beauty at the surplus steel yard. At 36" x 72" it's about twice as big as I had planned, but I figured for $150 it was a pretty good deal.
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2361.jpg
Things I'm looking to add:
cutting table
6" Vise
lower shelf
clamping rails
casters?
possibly some other accessory ideas I've come across
I picked up a piece of catwalk grate for the cutting table. I may need to go back and pick up more if I want to use the entire opening in the table.
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2364.jpg
While at the yard I found a bunch of these progressive cavity pump rotors....not sure what the **** I'm gonna do with it.:laughing:
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2362.jpg
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2363.jpg
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2361.jpg
Things I'm looking to add:
cutting table
6" Vise
lower shelf
clamping rails
casters?
possibly some other accessory ideas I've come across
I picked up a piece of catwalk grate for the cutting table. I may need to go back and pick up more if I want to use the entire opening in the table.
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2364.jpg
While at the yard I found a bunch of these progressive cavity pump rotors....not sure what the **** I'm gonna do with it.:laughing:
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2362.jpg
http://tamor.us/members-rigs/albums/Cruiser-rebuild/DSCN2363.jpg