PDA

View Full Version : Wanted: Chevy NP205


KrazyKarl02
03-08-2009, 04:45 PM
I need an NP205 for a chevy, not in a big hurry, but seeing if anyone has one.
mudtoy67
03-08-2009, 04:50 PM
You need the whole thing or just the tail housing? If just the tail housing I believe you can also use one from a Ford 205...that's what I swapped on to my old 205. That could open up your options when looking.
Sharpe
03-08-2009, 05:04 PM
Northwest Fab has a billet housing and cover kit for a 205. If a ford one will work I have one at my shop I'll sell ya cheap.
bcolman
03-08-2009, 06:02 PM
if you are looking for the whole thing what spline count will you need?
KrazyKarl02
03-09-2009, 11:13 PM
I will need to research the spline count and if Ford parts will work. It is mated to an auto TH350, but I think they made 2 spline counts for that. Right?
KrazyKarl02
03-09-2009, 11:21 PM
This website appears to be bad arse:

http://okcnetworks.com/bronco/205/np1.htm
bcolman
03-09-2009, 11:35 PM
if its mated to a th350 then it is a 27 spline 205 and are much harder to find
Eckert
03-10-2009, 04:21 AM
if its mated to a th350 then it is a 27 spline 205 and are much harder to find

but that is the input, technically all he needs it the tail shaft/housing, so wouldnt any np205 work?
bcolman
03-10-2009, 09:46 AM
i know that any chevy would work, i was just saying that if he wanted to find a whole replacement case
DRAGOONRANCH
03-10-2009, 10:05 AM
I have a racetrack style 10 spline at the house if you need one that bad.
Sharpe
03-10-2009, 11:39 AM
but that is the input, technically all he needs it the tail shaft/housing, so wouldnt any np205 work?

No, he needs a fixed rear output. Beyond that, any Chevy 205 seal retainer should work and a ford one might too.