PDA

View Full Version : HPD30 non Vacuum disconnect


breckboarder55
10-07-2009, 07:20 PM
Like it says:
HPD30 non Vacuum disconnect
Out of a cherokee porfavor
AggieTJ2007
10-07-2009, 08:24 PM
? the are not that much stronger but i guess it wouldn't be a bad upgrade if you are already doing gears and such. go to the junkyard and pick up a whole one and then you even have a spare set of shafts.

if you find one that is a disconnect you just replace the inner seal and put your TJ shafts in it w/ a blocker plate and it will work fine.
breckboarder55
10-08-2009, 06:48 PM
? the are not that much stronger but i guess it wouldn't be a bad upgrade if you are already doing gears and such. go to the junkyard and pick up a whole one and then you even have a spare set of shafts.

if you find one that is a disconnect you just replace the inner seal and put your TJ shafts in it w/ a blocker plate and it will work fine.

They are so cheap and are a direct bolt up I just figured I would throw one like you said with a gear/locker install... Until I convince myself to just move to something bigger...