Front driveshaft

[JB]

I need a stock Ford Bronco/F150/klogger, front driveshaft. The one I have in there is the original. It sheared itselft in two on the old crossmember, and we welded it back together at Katemcy, so spare is needed just in case. I am not sure what joint it has at the axle, but it is a fixed yoke up top.

[BroncoJo]

I need a stock Ford Bronco/F150/klogger, front driveshaft. The one I have in there is the original. It sheared itselft in two on the old crossmember, and we welded it back together at Katemcy, so spare is needed just in case. I am not sure what joint it has at the axle, but it is a fixed yoke up top.

I should have one, but you'll need to come over and identify it.

[Shaggy]

i have a couple. will bring to clayton

[KrazyKarl02]

I think I have 3.... Can you get a fully compressed yoke to yoke measurement?

Also was your bronco originally a C6 with a 208. The AOD and manuals are different lengths. Further, does yours take 1330 u-joints, some of them had 1310's in them.

Ahh, the many options for Fords....

[JB]

I will measure it this weekend. It was originally, and still is, an AOD/135x. Would it be possible that the yoke on the pinion from teh TTB and the yoke on the pinion of the D60 were teh same. It has been a awhile, but I do not remember if I changed that u-joint.

If I ever get some bling driveshafts built, what is the mack daddy of D60 yokes? 1410?

[Shaggy]

the ones i have are c6 but i can measure them later. i am planning on bringing lots of spare parts that i have laying around and have no use for. maybe someone will need them

[DRAGOONRANCH]

yes, 1410

[JB]

Front driveshaft as it sits, measures 36" from yoke to yoke. It might compress say 4".

[KrazyKarl02]

I'll try to measure my stash tonight, I keep meaning to, but forget.

[KrazyKarl02]

Front driveshaft as it sits, measures 36" from yoke to yoke. It might compress say 4".

I measured one of my "spares", fully compressed it is 35.75 inches edge of yoke to edge of yoke. Will that work?