View Full Version : ford d44 hubs
Eckert
01-02-2010, 01:47 PM
the hub itself, not the lockout. 1976-1984 or 1987-1995
both sides, need nothing else.
thanks
the spindles? i will look, might have.
stx4wheeler
01-03-2010, 12:34 PM
You are saying you need the cast metal hub that the rotor attaches to?
Eckert
01-03-2010, 02:01 PM
You are saying you need the cast metal hub that the rotor attaches to?
yes
Eckert
01-04-2010, 10:13 PM
anyone?
seth, do you still have these laying around?
http://www.tamor.org/forums/attachment.php?attachmentid=8119&stc=1&d=1144804336
85cj7
01-04-2010, 10:15 PM
i do but they are on the jeep and can't take off until I get 8x6.5 wheels to run.
colman
01-05-2010, 01:28 AM
ttb and regular d44 hubs and spindles are different. i tried to make a kit with ttb for a reg d44 and it wouldn't work. may work for your dodge but not on a reg d44
stx4wheeler
01-05-2010, 01:32 AM
Pm sent
Eckert
01-05-2010, 01:39 AM
ttb and regular d44 hubs and spindles are different. i tried to make a kit with ttb for a reg d44 and it wouldn't work. may work for your dodge but not on a reg d44
Mr. N and a few other write ups said the hubs were the same minus the few years in the 80's. ford caught the gay throughout the years and used different style spindles, but the bearings all looked like they stayed the same size as well as placement.
ideally i would like to find some form a 76-79 but im cheap. and TTB is even cheaper.
colman
01-05-2010, 02:02 AM
well maybe i should have kept the vented rotors and hubs that i gave frick a few years ago
Eckert
01-05-2010, 02:36 AM
well maybe i should have kept the vented rotors and hubs that i gave frick a few years ago
I need to play around with rotors as well, seeing as ford, dodge, jeep used 5x5.5. im hoping to find the ones with the correct thickness and spacing.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.