Free ****- Dana 60 stuff

[stx4wheeler]

Two stock 3.54 60 carriers, one will come with 31 spline spiders, and bearings, but no cross pin, the other will come as a bare carrier.

I think I have another 4.10 ford hp carrier, but it is pretty rusty

two sets of 3.54 gears for Dana 60 STD rotation

stock dodge push pull Dana 60 steering arm

pair of 60 rear shafts from a ford van, shafts are different lengths 31 spline-$35





I will update more as I finish rebuilding them.

[stx4wheeler]

Going to the scrapyard soon unless someone wants it.

[RCcola55]

Frick, can you pm me the info on the 35 spline rear conversion

[JB]

i still have 2 60 stock hubs if anyone is interested.(like where the wheel bearings live, not the locking part) Also have 1 stock Ford spindle.

[KrazyKarl02]

i still have 2 60 stock hubs if anyone is interested.(like where the wheel bearings live, not the locking part) Also have 1 stock Ford spindle.

JB, I will take them off of your hands.

[colman]

i'll take one of the sets of 3.54 gears...

[stx4wheeler]

Colman when are wanting to get them, sooner would be better than later, where are you living these days.

[colman]

i'm a nomad, i'm kinda living with dad in memorial, or at corey's ranch in montgomery. i'm waiting for my new job to start soon so i can get a paycheck and move out. i'm looking for a house with a buddy in the heights so i will be there in the near future.

[jrdixon89]

im needing a drive shaft know anyone that has one or where i could get one fast mine snapped on my daily driver

[AggieTJ2007]

go to Brazos Valley Driveline and have them retube yours or put a new yoke on it whatever you need. It will be better than a used one and maybe even cheaper, plus you will know 100% that it is the correct length

[BroncoJo]

im needing a drive shaft know anyone that has one or where i could get one fast mine snapped on my daily driver

Ask random tech questions here:
http://www.tamor.org/forums/showthread.php?t=10236&page=155

[DRAGOONRANCH]

Couple of JY's in Bryan. I never go to them, so don't know their names or reputations. I think there is a thread floating around about them though.

[jrdixon89]

ended up costin $600 when it was all said and done last semester ***

anyone have any dana 60 or 1970 / 1980s chevy parts not interested n anymore hit me up