front driveshaft - non CV

[mudtoy67]

Looking for a 1310 driveshaft. Something like from a CJ or YJ without CV and with the smaller diameter tube (2" I think)?

[85cj7]

If you can wait, I will be taking off my front. It is the stock cj7 sleeved with 1.75x.120 HREW. It won't be available until Sept. or Aug. though. I'll let ya know.

[colman]

stock cj is 1.25

[Shaggy]

I have a pretty big pile of shafts. Do you know t a stock tj one will work?

[mudtoy67]

Stock TJ would work, but it has a CV...no? I'm not opposed to it, I'd have to steal a regular yoke from another shaft.

[mudtoy67]

stock cj is 1.25

I think even that would be worth a try, I've got pretty tight clearance. Seems the ujoint always goes out before the shaft on those.

[colman]

ive broken several ujoints and pretzeled several shafts. i know other people have as well. Is this on the xj? what size tire? if your not going to big it will work. do you have a locker? or just the open carrier from me?

[mudtoy67]

Ya, I must be thinking of something else.

2" is stock for the XJ.

Locker, 35s or 37s. sh!t'll hold.:laughing:

[colman]

go for it. i have the same shaft on my cj with locker and 36" tsl's. haven't wheeled it as much as i would have liked but it has held for the last few runs (or years).

[mudtoy67]

Well since you're suggesting it I for sure can't do it now...:flipoff2:

[Shaggy]

Tj front shaft is non cv

[mudtoy67]

That would work then. What diameter is it?

[Fredo]

You could use a scout one. They use a 1.25" diameter front shaft. I probably have a few laying around. Let me know.