View Full Version : Who fabricates?
TXsizeK5
09-17-2003, 06:25 PM
Anyone have the tools (bender/welder) & wanna help or show me how to build a roll bar/cage for a K5
I just wanted to see a show of hands of who's good at fabricatin'
Well not for free...I'll get ya'll some beer or something. :D
aggielr
09-17-2003, 06:36 PM
i can do it, but it'll cost more than beer
http://xxxtraction.com/images/cage/DSC00447.jpg
we can do something like this, or if you have your own design in mind
TXsizeK5
09-17-2003, 06:48 PM
I was thinking of it looking more likea roll bar in the rear... but that setup looks alot like what I want mine to end up with, fender/tire/lift wise.... are those 38.5's?
aggielr
09-17-2003, 07:00 PM
1
Fredo
09-17-2003, 08:46 PM
No landon, He asked who is GOOD at fabrication. :flipoff2:
aggielr
09-17-2003, 09:14 PM
dang, i musta misread that part, all i saw was fabrication, didn't know it had to be good :flipoff2:
eight
09-17-2003, 10:00 PM
I think he just wants a roll bar kind of like my jeep stock one. Just a hoop behind the cab and 2 diagnals going down into the bed, and a cross bar in the hoop. Would probably want 2" tube on a blazer.
TXsizeK5
09-17-2003, 10:17 PM
Well i've already talked to Landon, and I had this in mind already....
http://www.angelfire.com/tx5/dc4x4/rollcageD1.JPG
aggielr
09-17-2003, 10:37 PM
those pics i posted were 1.75, and thats what my dies are
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.