Rectangular Tube

[sasquatch]

Does anyone know if Bryan Iron and Metal has rectangular tube? Looking for some 2x6 or so. Might make my bumper project a little easier.

[TxCruzr]

Not sure where I got the metal for my rear bumper but it might have been there. Had tons of of it.

[uglyota]

whatever you do, don't look up their phone number and call them and ask...we know much more about what they stock than they do.

[Chadnutz]

Go to Mack Bolt and Steel on 21. They keep their stuff indoors and they have a good selection,

[Fredo]

Yeah, I second the Mack recommendation. They were nice guys, kept almost all of the steel inside, and ordered in some 2x5 3/16s for me when I did my bumpers. Not only did they not have a problem with ordering in just 12ft for me, they even went ahead and chopped it into 2 6ft pieces for me so I could haul it in my scout.

[BigRedFord04]

Mack Bolt: 979.778.8088

Brazos Industries: 979.775.9433

Custom Fab: 979.775.4297

Brazos Industries is out off 2818, they supply Vilas w/ most of their steel. Tate's had good luck w/ Custom Fab.

[sasquatch]

sweet. thanks

[savvyaggie]

how thick?????

[sasquatch]

Not too thick. Its going on the front of the ZJ. 3/16 or less.

[BigRedFord04]

use at least 3/16".

[TxCruzr]

I went to Macks too....don't listen to me on the first post, that was my ADD talking
Talked them into giving me some "scrap" metal for the trailer hitch for free :D

[savvyaggie]

i have some 1/8 inch 2x6

[Shaggy]

i really like custom fab

[uglyota]

they charged me $35 for 2 feet of 3.5"x3.5"x.25" square tube

[Shaggy]

who did?

[uglyota]

custom fab
in their defense, they were the only place within 100 miles that carried it

[Shaggy]

they have always been reasonable on prices with me... they will even bargain with you sometimes