View Full Version : Dana 44 spindle.
AggieTJ2007
11-07-2005, 12:48 AM
Does anyone have one laying around that I could borrow for a little bit. I promise I will give it back shortly.
Actually all I need are some measurements off of it. Preferbly a Jeep spindle, but any will work.
73bronco
11-07-2005, 10:39 AM
Does anyone have one laying around that I could borrow for a little bit. I promise I will give it back shortly.
Actually all I need are some measurements off of it. Preferbly a Jeep spindle, but any will work.
WTF why didnt you tell me this before I put the front end back together. Well too late now so good luck
AggieTJ2007
11-07-2005, 05:12 PM
i just want to know the diameter of the hole in the knuckle that the spidle sits in
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.