PDA

View Full Version : some progress



aggielr
10-19-2002, 05:58 PM
i got this done this weekend, i have to fix some shiat, since i made the hangers too close together, the shackles are pointed to far back, but oh well, more damn work

aggielr
10-19-2002, 05:59 PM
2

aggielr
10-19-2002, 05:59 PM
3

robertf03
10-20-2002, 12:54 AM
well, looks to me like you moved your shackle hanger back about 3" and your main eye hanger back about 8"

aggielr
10-20-2002, 11:38 AM
yea, i did, before i put wieght on it, it looked ok, but afterward, well...., i'm goin to make a new rear crossmember and bumper and put the shackle hangers on the bumper

aggielr
10-31-2002, 08:52 PM
this is with no wieght on it, with me and my roommate on it, it kicks them out some, we'll see how it works out

aggielr
10-31-2002, 08:52 PM
2

aggielr
10-31-2002, 08:53 PM
what do you think of these, any comments, constructive criticisms?

Doug Krebs
11-01-2002, 11:32 AM
they look decent, but you can tell where you start and stop, and it looks like you may be going a little fast

aggielr
11-01-2002, 11:33 AM
yea, someone pointed out the too fast thing, and thats 1/4 and the duty cycle is what the start and stop thing was, i hate that

redcagepatrol
11-01-2002, 02:36 PM
Where is that weld? Does your welder cut out at the duty cycle to where you have to stop?

Looks good though

I am like you: I will never finish...EVER

aggielr
11-03-2002, 06:48 PM
that weld is the one's from the crossmember to the bumper, and yea, the duty cycle causes me to have to stop, but the welder doesn't stop welding, it just starts spattering and you can tell by the way it sounds its strainin, and i read on the miller info page, that you have to stop, otherwise it could fawk up the internals

aggielr
01-09-2003, 09:09 PM
a couple more, havin no money really sucks, but here is the front outboard hanger part and extension and i have main eye hanger tacked in place till i get the springs

aggielr
01-09-2003, 09:10 PM
2

aggielr
01-09-2003, 09:11 PM
3

aggielr
01-09-2003, 09:13 PM
this is what i'm goin to make both sides like, and i'm goin to put a piece of flat bar across the front tilted back connecting the bottom piece of plate to the top of the cross member for a bumper