PDA

View Full Version : 727 problem, i think


95discovery
10-31-2006, 04:30 PM
recently the jeep has been acting like a jeep. Once coming to a stop after running for a bit the engine will die. It sounds like a manual does if you slow down without putting the clutch in. Im thinking its the torque conveter locking up and not releasing. Any other suggestions?
sasquatch
10-31-2006, 04:33 PM
i concur
95discovery
10-31-2006, 04:42 PM
also forgot to mention that if you put it in neutral before it stops, then put it back in gear after it stops, itll idle fine.
fbronco86
10-31-2006, 04:56 PM
also forgot to mention that if you put it in neutral before it stops, then put it back in gear after it stops, itll idle fine.

Sounds like the valve body is hanging up. Might try fluid change and a filter.
agjohn02
10-31-2006, 06:10 PM
i concur with mike. torque converters are more likely to not engage than not disengage. they usually make noise too.
eight
10-31-2006, 06:19 PM
727 got lockup converter?
95discovery
10-31-2006, 07:02 PM
727 got lockup converter?

aye


and thanks for the input, hopefully ill get a chance to work on it this weekend or next, once all this school **** calms down. for now ill just drive it like a stick and put it in neutral every stop.
TMatheaus
10-31-2006, 07:22 PM
put a can of the k&w trans-x in it, it might help free a valve if its sticky
95discovery
10-31-2006, 07:24 PM
well the fluid and filter was replaced not too long ago. One of the springs borke a while ago and just left shards in there, so thats more than likely the problem. I thought we got all of the pieces out before but i guess not.
TexTJ209
10-31-2006, 07:43 PM
http://dallas.craigslist.org/car/227839651.html


Manual tranny swap ftw.
Reckless
10-31-2006, 07:47 PM
In a couple of months, ill sell ya my TF999 thats beefed up and just rebuilt
colman
10-31-2006, 07:52 PM
ive got a t400 froma waggy that you can have for cheap if yours craps out on you, came from a waggy....kinda our waggy
95discovery
10-31-2006, 07:52 PM
http://dallas.craigslist.org/car/227839651.html


Manual tranny swap ftw.


any idea what tcase was in that and which side drop it was?
TexTJ209
10-31-2006, 08:10 PM
ive got a t400 froma waggy that you can have for cheap if yours craps out on you, came from a waggy....kinda our waggy


That'd most likely be the AMC version of the TH400, with the output meant for a quadratrac. It'd be a little more difficult.



any idea what tcase was in that and which side drop it was?


Pretty sure all waggys of that era were the same side drop(driver's), and being a manual tranny that should have an NP208 I believe.