Wanted Jeep 360-5.9 Timing chain cover

[stx4wheeler]

the timing chain cover on my deerleese waggy has a hole in it, anyone got one laying around they wanna sell, cheap used is better, but new can work if nothing else-fred you got anything for my.

[TMatheaus]

jb weld the hole shut

[stx4wheeler]

ita about dime sized but i may try that with some muffler patch. if i get bore theis weekend.

[sasquatch]

weld a plate over it

[bburris]

It's for a 360, anything we have would probably be made of gold...

[Fredo]

I'll see what I can do.

[stx4wheeler]

its not made of steel cook, so welding it would outside the realm of feasibility for me.

[fbronco86]

jb weld a patch on it.

[DRAGOONRANCH]

x3 on da JB, one can never have enough spare tubes of JB lyin around. ;)

[stx4wheeler]

for temporary im thinking, peice of that muffler platch mesh,with jb over that, or use a bolt head that is slighty larger than the hole, and jb it.

the hole is around dime size if i remember correctly. the jb weld will match the rest of the waggy. When the front rotors blew apart from being old and rusty, what did i do?replace the rotors.Wrong i bought a brake connection spliter from napa and put all the brakes to the rear.

[sasquatch]

the hole is around dime size if i remember correctly. the jb weld will match the rest of the waggy. When the front rotors blew apart from being old and rusty, what did i do?replace the rotors.Wrong i bought a brake connection spliter from napa and put all the brakes to the rear.

not sure i'd be proud of that

[jerryg79]

for temporary im thinking, peice of that muffler platch mesh,with jb over that, or use a bolt head that is slighty larger than the hole, and jb it.

the hole is around dime size if i remember correctly.

i say use a nickel then

[DRAGOONRANCH]

i say use a nickel then

the sad part is it would probably be cheaper than the bolt once you figure the cost of the bolt, time to find it, and cost of grinder wheel if you have to cut it down any. ;)

[AggieTJ2007]

for temporary im thinking, peice of that muffler platch mesh,with jb over that, or use a bolt head that is slighty larger than the hole, and jb it.

the hole is around dime size if i remember correctly. the jb weld will match the rest of the waggy. When the front rotors blew apart from being old and rusty, what did i do?replace the rotors.Wrong i bought a brake connection spliter from napa and put all the brakes to the rear.

Its at the deer lease, I just hope there are plenty or trees to run into when youcna't stop

[colman]

call junior he has several 360's and lots of parts

[stx4wheeler]

it stops awesome especially since its top speed is short bouts of 50 or so. Also now you can do wicked j-turns and slides when you lock up the brakes on dirt and gravel.