View Full Version : 1/4" or 3/8" plate
JeepPhisherman
04-18-2007, 10:39 PM
Anybody have some 1/4" or 3/8" plate they aren't using? Preferably in the CS area. Trying to get a new skid built for the toy before tcc.
Does Mack carry plate?
Or I could use some 1/4"x 5 or 6" flat bar.
CRaSHnBuRN
04-19-2007, 06:13 AM
yes, all the steel places should carry plate, though they may want you to buy an entire sheet
agjohn02
04-19-2007, 06:33 AM
bryan iron and metal has mill plate cheap in 3/16" and 1/4". all the steel i have used on the jeep has come from there. you do not want to pay for regular plate. it is expensive.
JeepPhisherman
04-19-2007, 07:48 AM
What's mill plate?
I actually only need like 5" wide strips, so I might just get some 1/4"x5" flat is Mack carries that.
RCcola55
04-19-2007, 09:56 AM
its cut up plate thats left over from mill work, there are some pretty big sheets out there. last i checked it was $.30/lb
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.