View Full Version : Kingpin bearings
CRaSHnBuRN
08-09-2007, 03:02 PM
anyone know of a source for just the kingpin bearings. Luis mentioned that o'reillys carried them (made by moog), but I can't seem to find them
spool
08-10-2007, 08:07 AM
Call me today at work after 12 and I will tell you the oreilly part number
Troy
940-323-8640
CRaSHnBuRN
08-10-2007, 08:14 AM
thanks
sasquatch
02-28-2009, 07:38 PM
Call me today at work after 12 and I will tell you the oreilly part number
Troy
940-323-8640
the part number for just the bearing is 23100 and the race is 23256. thats timken/bca/national. guess the secrets out
AggieTJ2007
03-01-2009, 07:29 PM
sweet, do you have the part number for the lower kingpin bearing too
DRAGOONRANCH
03-01-2009, 11:10 PM
This came off the 60 bible. Is this what you were looking for?
Dana/Spicer #
706150x
Lower kingpin bearing and race
Reckless
03-01-2009, 11:47 PM
Whats the link for the 60 bible?
DRAGOONRANCH
03-02-2009, 01:56 AM
Page 1
http://www.pirate4x4.com/tech/billavista/60_front/index.html
Page 2
http://www.pirate4x4.com/tech/billavista/60_front/index2.html
I had to look up the links again because last time I looked for it, I just went ahead and saved the page on my ext. hard drive so I could surf it when I didn't have any internet connection.
uglyota
03-02-2009, 05:38 PM
don't think there was any secret. I think Troy was working at Oreilly at the time
CheapJeep
03-02-2009, 05:58 PM
All of Billavista's writeups are under the tech section on the pirate homepage.
http://www.pirate4x4.com/tech/
DRAGOONRANCH
03-03-2009, 03:25 AM
All of Billavista's writeups are under the tech section on the pirate homepage.
http://www.pirate4x4.com/tech/
Bah! Don't go giving our secret stash away like that!!!
AggieTJ2007
03-03-2009, 05:48 PM
I think I am just going to go with the full kinpin requild,
Krebs do you still have that massive allen wrench?
or should I just leave the kinpins alone if they look like they are in good condition
sasquatch
03-03-2009, 08:29 PM
no reason to replace them if they aren't pitted.
sweet, do you have the part number for the lower kingpin bearing too
those part numbers are for the lower bearing and race. there isn't really an upper bearing.
AggieTJ2007
03-04-2009, 09:52 AM
alright thanks
Doug Krebs
03-04-2009, 10:06 AM
Krebs do you still have that massive allen wrench?
I'm pretty sure Cook has it...
sasquatch
03-05-2009, 11:00 AM
I'm pretty sure Cook has it...
yea, its in my toolbox somewhere. I had forgotten about it until now. i need to use it for the pass side, then i'll return it to you.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.