Since the shop is a little slow right now i've started working on the heep some. at the rate i'm going maybe one day it will be finished.
Printable View
Since the shop is a little slow right now i've started working on the heep some. at the rate i'm going maybe one day it will be finished.
So what's the plan on this one? I know it's supposed to be milder than the last, but it should still get at least 38s.
i'm planning on running 40'' goodyears.
that'll workQuote:
Originally Posted by chevsu
I want a diff shaving machine :(
maybe you can buy that one.
I doubt it :)
this chunk of iron fell out from under a truck driving by. maybe it will fit in the jeep
Oooohhh. I have NV envy.
Quote:
Originally Posted by uglyota
a.k.a.- a mill or a sawzall/grinder.
that would be a millQuote:
Originally Posted by Captain Obvious
if you look close you can see the frame is bent in the front.
getting time to order the transfer case
LMAO....you're an idiot :flipoff2:Quote:
Originally Posted by uglyota
I knew that was a mill when I wrote that, butt-nut.
You don't remember showing me one?
:flipoff2:
Quote:
Originally Posted by uglyota
i figured you knew that. i wasnt trying to be captain o, just saying you can do the same with a sawzall and grinder. it just might not be so pretty.
LMAO....butt-nut.....i'm gonna have to use that. :gigem:Quote:
Originally Posted by uglyota
now that you mention it, i might remember that....but i was probably drunk, or hungover, as it went my last couple weeks in CS.