Frag'd mine, need a new one pronto to get the DD back together. TH400 one will NOT fit.
Printable View
Frag'd mine, need a new one pronto to get the DD back together. TH400 one will NOT fit.
****, i just sold mine
$25 from the dealer, can get it tomorrow morning. Still tryin to find one today though.
why is this something you need ASAP. is it needed to drive the truck?
I bet john's transmission would sell you one
Technically not but considering I would have to drop the exhaust and front driveshaft again to re-install it later, I want to get it replaced before I put everything back together. Its also proven to have done its job of protecting the torque converter once already, so its worth replacing. Not to mention the 6 bolts holding it to the transmission bellhousing and 2 torque rods that bolt to it tell me its somewhat structural in nature.Quote:
Originally Posted by agjohn02
ah, im thinking of a 4L60E with the little plastic dust covers. i wasnt aware that an 80 had a full lower cover similar to the old syle.
How'd you frag it?
Trying to hammer a dent out. Cast aluminum only like to get bent once...
ok, how'd you get the dent in it?
Dunno.
just put some duct tape over the hole
frag'd=fragmented
=duct tape don't fix that
It does if you use enough of it.Quote:
Originally Posted by uglyota
jb weld?