will doQuote:
Originally Posted by afroman006
Printable View
will doQuote:
Originally Posted by afroman006
I only run tires slick on the jeep. None of the ones I'm offering are slick. Turns out I ended up with some 40s to replace the 38s on the jeep while they still had what could be recognized as tread. Hummer tires suck unless you cut them up like mine were, before all the tread wore off.
free hummer tires trump all paid for tires.
was going to start today but I cant find my 13/13 and 7/8 impact sockets, will start tomorrow. I could really use a hand unloading the truck if anyone is free tomorrow.
Quote:
Originally Posted by BroncoJo
:confused2 :confused2 :confused2
Quote:
Originally Posted by Reckless
why does it not surprise me that you cant figure that out?
:D :gigem:Quote:
Originally Posted by agjohn02
not fluent?!? If it werent for you the language would be dead :flipoff2:Quote:
Originally Posted by Reckless
I need a bender to make a cage for clayton but I dont want to spend the money on a jd2 and the dyes but I think I could make this one work.
http://cgi.ebay.com/Round-Tubing-Ben...QQcmdZViewItem
Any thought?
great deal and should be a good bender. Have seen lots of threads where people make basically that same bender. I like that you are bending vertically instead of horizontally with it. Seems like it would be easier to keep your angles right that way. Might have to get me one....hmmmm....
Find the trike builder plans and build your own. May take a little bit longer, but you can come out cheaper with a product you know is well built.
from the design i think multiple plane bends on a single piece of tube would be a *****
That one is a little bulky, but is there any time multiple plane bends on a single piece of tube aren't a *****?
I found the plans at gottrike.com but they want to sell them. Are they posted anywhere for free? I kinda like the looks of that because it looks like tighter and 180 bends can be preformed. From the looks it uses a dye from a jd2 and that would cost about the same as the one I posted up.
The bad about the one I posted is that there is a max bend of 90 and it bends on a 7 inch radius.
I don't know if anyone is sharing the got trike plans, but I'd bet there are a few people on here who might chip in on the plans.