i believe these trucks only came with 3.55's or 4.10's but i could be wrong
Printable View
i believe these trucks only came with 3.55's or 4.10's but i could be wrong
Fixed passenger side floor to hopefully prevent anyone from falling through. and removed glass.
i don't know if somebody has said this yet, but the ratio is stamped on the ring gear.Quote:
Originally Posted by BroncoJo
way to get after it. the clock is ticking for both of us
Got the other side patched up, looks just like pictures above so I didn't bother with new ones. Also got my shop rearranged to get ready for the motor swap tomorrow.
plans for the weekend.
finish rear suspension (rear hangers are rusted through)
trans swap
motor swap
fab exhaust from bronco to fit
wire it up
still need the houst, just call me tomorrow and there should be someone home so you can get into the garage
Everything that could have gone wrong did. Got all the drive train out and ready to be swaped. Will start again tomorrow afternoon.
will not alow upload of picture will mess with it tomorrow
Got the motor, trans, and t-case in. wire start to wire it up tomorrow and work on suspension.
your name needs to be broncotrav
good deal with the progress
Got the rear drive shaft shortened, power steering hooked up, swaped a 1 ton steering colum in and all the linkage, got the headers on, fixed rear shackle issue. wont be able to do much until next weekend.
nice now the truck is part 1991
hell ya, the only parts i have had to buy so far are 2 exhaust manifold gaskets.Quote:
Originally Posted by william_ace
Are these picture turning out un really big?
i put a limit on the picture size. 800x600
those headers are slightly ridiculous, but nice progress
I'll get them sized better from now on. they were ****ing huge at the schoolQuote:
Originally Posted by RCook527
Those were the only full lenth headers I could keap protected on the bronco, they dont hang below the t case like all the others did. I will probably make a slider for them on this truck and keap the exhaust run right under the body.
Ordered a gate style shifter and new (lower) rpm controll module today. I know (and dreading) that this is the start of a new money pit.
Does anybody have a couple feet of square tubing? doesnt have to be 1 piece, maybe 2x2 or close. I'm just going to put the hood on pins since the latch is ****ed, and they make such great sleds.
Will be wrenching later if anyone wants to come help.
there is a sh*t load of 2x2x1/4" tubing at my house that tommy brought over yesterday, i bet he would let you use some. Talk to hima about it, its in the garage.