The General

ill get some when i get home from the library

did you get lost in the stacks????

:flipoff2:

i just got home 30 minutes ago, and since it is dark the pictures will suck so i will post some tomorrow when i should have the hydro assist done or close to it to post also

ya ****in tease.....

here are some pictures, today has been slow because of the rain and lask of space in my garage to work on my stuff cause my brother takes up most of it, but i do have everything for my rear drive shaft i just need to weld it up and then i will get the hydro stuff done later this week

pictures:

looks good

i got the rear drive shaft built today, i just have to finish welding it tomorrow and add a little paint and grease and i will have 4 wheel drive again

Quote:

---

Originally Posted by bcolman

cause my brother takes up most of it...

---

get a chain and drag his pile of poo on down to the scrapyard, he will thank you for it later. ;)

and x2 on what creighton said. :gigem:

what size tube is the driveshaft, i know ive candycained 2in with 1.5in inside before and that was on the front!

Quote:

---

Originally Posted by DRAGOONRANCH

get a chain and drag his pile of poo on down to the scrapyard, he will thank you for it later.

---

i have threatened and since then i have gotten some space, it has taken almost a year and he has given me about 1/4 of the garage, but i cant complain to much because all the tools are his

Quote:

---

Originally Posted by RCcola55

what size tube is the driveshaft, i know ive candycained 2in with 1.5in inside before and that was on the front!

---

yah but not everybody drives like a drunk monkey either;)

i'm a bit of a packrat but everytime something is needed i seem to have one somewhere or something that we could make work. if i had some time then i could put my new jeep together. i have 95% of the parts. Or maybe i should stop acquiring new projects and fix the ones i have. i now have 2.5 jeeps and a chevy 5/4 ton

Quote:

---

Originally Posted by DRAGOONRANCH

get a chain and drag his pile of poo on down to the scrapyard, he will thank you for it later. ;)

and x2 on what creighton said. :gigem:

---

also i think he needs a better set of rims. right now there are 7" wide stockers. anyone know where any 16" beadlocks are?

Quote:

---

Originally Posted by RCcola55

what size tube is the driveshaft, i know ive candycained 2in with 1.5in inside before and that was on the front!

---

its 2 inch with 1.5 inside, this is just temporary till i order the cv output for the 205 and get a cv shaft made, i just dont have that kind of money right now and am short on time