WTB:
Spring Perches
Shock Hoops
8 lug wheel spacers
ubolts/plates 14bolt or dana70 size
14bolt driveshaft joint and straps
6" Hydro ram
Printable View
WTB:
Spring Perches
Shock Hoops
8 lug wheel spacers
ubolts/plates 14bolt or dana70 size
14bolt driveshaft joint and straps
6" Hydro ram
I have 8 lug spacers 2"
i was hoping to get some 1"-1.5" but how much do you want? i only need 2
I think I have a used toyota hydro-assist ram.
my brother may have a set of spring perches, ubolts and plates
KrazyKarl02 please get me some pics and a price. bcolman same for you, please make sure they are for a 3.5" axle tube cause its for a 14 bolt rear axle.
thanks guys, please get back to me asap cause i need it all as soon as possible.
14bolt driveshaft joint and straps
Do you mean a u-joint and straps? You can get both from napa for cheap.
I need the drive shaft part too, I'm making a custom driveshaft with toyota at the tcase end and then 14bolt at the other end.
$100 for a pair
You need a weld yoke? What u-joint size? You can get them for about $40-$50 from a driveline supplier.Quote:
Originally Posted by 95toyrunner
im not sure the size, stock 14bolt size i assume. im probably just gonna pull one from a junkyard.
I've bought brand new ones with lug nuts for less than that.Quote:
Originally Posted by Shaggy
Likely 1330, maybe 1350. You can measure the cap diameter and width and compare a chart to find out the u-joint size.Quote:
Originally Posted by 95toyrunner
I am fairly certain that they make an adapter flange to run a Toyota driveshaft without making anything custom. I may be thinking of a d-44. It's worth looking into before you piece something together.
Well they cost me a hell of a lot more to have made and they have lug nuts with themQuote:
Originally Posted by Sparling
What are they made out of
Steel. Villas built them
Steel is mo betta than al-you-minimum. I would buy them from you tate if the red dirtymax was back on the road.
I'd buy them if they were metric.
Ah, to have Ford problems... :flipoff2:Quote:
Originally Posted by Sparling
(yes, mine are 210mm/8.25" now on the new dually.)
ive got a set of d60 and d70 gears 4.56 if your gonna gear that axle
Picture of said ram. Looks worse than it is, probably was in use for 6 months before I scrapped the klogger, rusty because it has been sitting outside for about a year. No leaks that I know of.Quote:
Originally Posted by KrazyKarl02
Attachment 19540
Karl, want to trade for a 2" ram?
specs on 2" ram? What brand? How long was it used, What's the stroke?
It came off of Scott's patrol. 2"x 8" I think. PSC. I've had it on the bronco for a couple of years. Works great, it's just too big for a tapped box.
My hydraulic assist cylinder is only a 6" stroke, will this work for you?
insert all of your asshole comments about a 6" stroke.... I will reply with your mom didn't mind it, but that night there were so many other guys around she probably didn't even notice.
Yep. I had to have a 2" spacer machined for mine anyway.
http://i736.photobucket.com/albums/x...IMAG0155-1.jpg
http://i736.photobucket.com/albums/x...IMAG0157-1.jpg
what cash price on both of yalls rams?