-
tbi problem
Ive been working on the Jeep the last couple of weekends, new throw out bearing, u-joints, etc. but now I have a new problem.
The last couple of times that I started it, it was running REAL rough. It wouldn't even idle. Sharpe came by and checked the codes and there was a bad temp sensor. I was fixin to leave to get the sensor, but today I started it again and noticed that only one of the 2 injectors are firing. Is there a way that I can test it it see if it is getting signal or to see if it is clogged up??
-
did it sit for a while? tap the injector with the handle of a screw driver. it'll start working again, probably.
-
it sat for a couple of months.... I already tried that with no luck....
-
-
hehe... I did, trust me....
-
not sure about TBI but most FI systems can be checked with a noid light. pretty sure you can borrow them from the parts store and plug it into the harness. if it flashes then the signal is fine.
-
It is the injector, I crossed the plugs, now I just got to get it unclogged!!!
-
soak it in berryman's then tap HARDER:)
-
i just took it apart, and got it unclugged. So now I have a new problem, its now putting out to much fuel!?!? :mad:
-
Im fixin to head over and just get a rebuild kit for it.
-
it won't rebuild the injector, it's just seals and ****. I've got some extry injectors, send me your address and I'll mail you one?
-
-
Let me mess with it a little tomorrow first, I think a little trash got in the o-ring groove. If so I should be fine, if not I will get the injector from you...
-
I have a couple of 5.7 injectors I'll throw your way if you needum. I can getum to you early saturday so lemme know asap tomorow.
-
It looks like I will be needing those injectors.....