Does anyone know if Bryan Iron and Metal has rectangular tube? Looking for some 2x6 or so. Might make my bumper project a little easier.
Printable View
Does anyone know if Bryan Iron and Metal has rectangular tube? Looking for some 2x6 or so. Might make my bumper project a little easier.
Not sure where I got the metal for my rear bumper but it might have been there. Had tons of of it.
whatever you do, don't look up their phone number and call them and ask...we know much more about what they stock than they do.
Go to Mack Bolt and Steel on 21. They keep their stuff indoors and they have a good selection,
Yeah, I second the Mack recommendation. They were nice guys, kept almost all of the steel inside, and ordered in some 2x5 3/16s for me when I did my bumpers. Not only did they not have a problem with ordering in just 12ft for me, they even went ahead and chopped it into 2 6ft pieces for me so I could haul it in my scout.
Mack Bolt: 979.778.8088
Brazos Industries: 979.775.9433
Custom Fab: 979.775.4297
Brazos Industries is out off 2818, they supply Vilas w/ most of their steel. Tate's had good luck w/ Custom Fab.
sweet. thanks
how thick?????
Not too thick. Its going on the front of the ZJ. 3/16 or less.
use at least 3/16".
I went to Macks too....don't listen to me on the first post, that was my ADD talking
Talked them into giving me some "scrap" metal for the trailer hitch for free :D
i have some 1/8 inch 2x6
i really like custom fab
they charged me $35 for 2 feet of 3.5"x3.5"x.25" square tube
who did?