Rear bumper
Printable View
Rear bumper
Tranny cooler?
steering, already has 2 transmission coolers
also moved the intake to fit a safari snorkel style ducting on the end of the mantec, dual battery, psc reservoir, some other stuff that no one would notice
Nice, sounds like a bulletproof setup.
what cooler is that?
http://www.pscmotorsports.com/motors...er-24-6an.html
The mounts on the cooler are kind of flimsy. I'm going to take some 1/4" round bar, smash the ends, drill holes in it, and use it as a brace behind the cooler to keep the vibrations down.
New GPS showed up.
http://img.tapatalk.com/d/13/02/19/ru9epe3u.jpg
http://www.flemcodesign.com/pics/300.jpg
rollin', in my 5.0
What engine is that?
buick 300
sounds like fun
I hope so, it'll sit in storage for a while before I do anything with it
I don't want to use the 64 buick heads, so I won't be following the same formula as the article above
I went through a bunch of piston cataloges and all of the off the shelf stuff is a compromise in compression ratio or odd overbores
so it looks like custom pistons...
If I use the buick 5.964" rods I need a compression height of 1.3, 25CC dish
If I use the rover 5.66" rods I need a compression height of 1.6, 25CC dish
The long rod would be better, but the 5.66 are way more common if the buick rods turn out to be crap.