No need for SS. Mine is 4" turbo back and was $180
Type: Posts; User: RCcola55
No need for SS. Mine is 4" turbo back and was $180
If its just pin holes don't weld it. You will create a headache for yourself chasing blow outs. They make a 2 stage tank repair product the uses acid to prep the inside the tank and the another part...
Pressure wash the **** out of it. Degrease the **** out of it. Pressure wash again. Scuff the **** out of it with a red scotchbrite or 220 paper. Pressure wash again, degrease again. Clean once,...
I've used Herculiner in three rigs, decent results. The key is, just like any automotive finish is to prep, prep, and prep again. Once you think you have it prepped, prep it once more. Also a light...
He was really more pissed because he couldn't get it in the scrap truck. Gave cook and I a good laugh
Mine was 1 5/8 and prenotched, it went together in a day. The claw at Bryan iron couldn't crush it. Good test in my book
S&w was 1 5/8 .120 when I bought mine. I don't think it's .318 wall
Edit: they offer .134 dom/hrew and 1 5/8 .083 4130cm
What are you needing it for
Why do that when can reduces the wire and keep from frying one coil.
People that do it your way don't understand wiring and audio ie the Community. And that's bad coming from me.
Run them in series and bridge at the amp.
You can start there. 2 ohms is normal. If you burn it up get a new one.
Huh? So you are saying bridging the channels, thus reducing resistance will cut your power output? Go re read your physics book.
Travis find out what the amp is stable at then wire you voice...
All depends on the potential loads. Most go b hoop and bent a-pillars to the b pillar. Others us a b hoop and halo with a pillar tie ins
1500
Wasn't the tech issue, read my quotes, it's his piece of **** attitude the makes hulk angry.
As far as tech, pull the ECM and have it flashed, easy as pie.
Now go back to your pathetic life.
Tired of hearing/reading your dumbass comments. Speaking for everyone.
What a ****ing douche!!!!! Drink bleach and die you moron.
Take it to Lance at creative audio next to j-codys, 979-268-8272 tell him you are with TAMOR.
I use the ryno-smash method, then find a new drum at a junkyard and put it into the magic bag
stainless sheet and some 320 sand paper
even if they werent, there are probably two cops and one inspector in the entire state that would know that law and be willing to say something about it. Its kinda like the beadlock law, not that big...
90% chance its cast steel, weld it like you would any other steel and you will be fine, like creighton said a little preheat wouldnt hurt
What Ryan said, but make sure you find a matching rear
why not synthetic, I put royal purple in my E4OD after the initial break-in and was like a dream
this