Search:

Type: Posts; User: Hot Pocket

Page 1 of 4 1 2 3 4

Search: Search took 0.11 seconds.

  1. Replies
    3,158
    Views
    541,559

    ediit: Here is a better diagram. ...

    ediit: Here is a better diagram.

    http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1-DVC-4-ohm-2-ch-low-imp.jpg

    Like it says, make sure the amp can handle a...
  2. Replies
    3,158
    Views
    541,559

    a monoblock amp is an amp with only one set of...

    a monoblock amp is an amp with only one set of outputs. if that is a 2 channel amp, you don't want to bridge it. Bridging it will present a 4 ohm load on the amp, and you will have about half the...
  3. Replies
    3,158
    Views
    541,559

    is that a monoblock amp? something about your...

    is that a monoblock amp? something about your setup doesnt look right.
  4. Replies
    3,158
    Views
    541,559

    Haha, it is my roommates car, and yes it's all...

    Haha, it is my roommates car, and yes it's all kinds of "african-american" awesome.. so what would be the solution here?? Get the PCM reprogrammed to just bypass the VATS system altogether? If I tow...
  5. Replies
    3,158
    Views
    541,559

    JB and FJaggie, what are you guys doing? Y'all...

    JB and FJaggie, what are you guys doing? Y'all are supposed to bust my balls and make me feel like a retard, not stick up for me! :laughing:

    Anyway, here's where I'm at:

    In all her beauty......
  6. Replies
    3,158
    Views
    541,559

    Well unless you have anything beneficial to add...

    Well unless you have anything beneficial to add to solving the problem, please **** off
    thanks and :gigem:
  7. Replies
    3,158
    Views
    541,559

    Who pissed in your cheerios clarke? :flipoff2:

    Who pissed in your cheerios clarke? :flipoff2:
  8. Replies
    3,158
    Views
    541,559

    So as it turns out my circuit is backwards, gotta...

    So as it turns out my circuit is backwards, gotta redo this sumbitch and pray for the best

    I'm at 50hz, it's just not an inverted signal :facepalm:
  9. Replies
    3,158
    Views
    541,559

    And yes, I do. Unlike GM, my circuit is not...

    And yes, I do. Unlike GM, my circuit is not designed to fail after 5-10 years.
  10. Replies
    3,158
    Views
    541,559

    Tommy, the method you have described is so that...

    Tommy, the method you have described is so that the VATS module can relearn the new key. Basically, GM had a variety of different resistors put into their keys, and if the resistor goes bad or the...
  11. Replies
    3,158
    Views
    541,559

    it's a 95 buick regal.

    it's a 95 buick regal.
  12. Replies
    3,158
    Views
    541,559

    I'll try the jumper to the fuel relay. As far as...

    I'll try the jumper to the fuel relay. As far as taking it somewhere to do it right, :rolleyes:
  13. Replies
    3,158
    Views
    541,559

    BDR- From what I've read, on this car the VATS...

    BDR-
    From what I've read, on this car the VATS disables both the fuel pump and the starter. I know that the VATS module was faulty because before we replaced it with out homemade chip, the car would...
  14. Replies
    3,158
    Views
    541,559

    Ok, so we made the circuit in the diagram and...

    Ok, so we made the circuit in the diagram and there has been some progress, but we aren't quite where we want to be.

    Before we made the circuit, the motor would not turn over at all. With the...
  15. Replies
    3,158
    Views
    541,559

    thanks BDR. I found this...

    thanks BDR. I found this http://home.hiwaay.net/~davida1/VATSbox.jpg

    I'll try to wire this together tomorrow and i'll post my results.
  16. Replies
    3,158
    Views
    541,559

    What you're talking about involves fooling the...

    What you're talking about involves fooling the VATS module into thinking that the proper input resistance is present. That is fine, except that it is the module itself which is faulty. I know there...
  17. Replies
    3,158
    Views
    541,559

    yes, VATS/Passlock same thing. The programmers...

    yes, VATS/Passlock same thing. The programmers cost a ton... is there another solution? I have read that it's possible to reproduce the output signal on the theft deterrent module while bypassing the...
  18. Replies
    3,158
    Views
    541,559

    Does anyone have any experience bypassing a...

    Does anyone have any experience bypassing a passlock security system? GM sucks.
  19. Replies
    3,158
    Views
    541,559

    The bronco I have has a HP 44, and it has 3.55's...

    The bronco I have has a HP 44, and it has 3.55's in it.

    I found this on another website...



    so carriers don't matter for high or low pinion, but gears do
  20. Replies
    3,158
    Views
    541,559

    Will a low pinion 44 carrier fit inside a high...

    Will a low pinion 44 carrier fit inside a high pinion 44 housing?
  21. Replies
    3,158
    Views
    541,559

    I have adjusted the drums all the way down. Used...

    I have adjusted the drums all the way down. Used a screwdriver since oreilly didnt have the tool (it was actually pretty easy to do with a screwdriver)

    These little bastards still wont come off.....
  22. Replies
    3,158
    Views
    541,559

    Have tried hitting the shoulder with a BFH... ...

    Have tried hitting the shoulder with a BFH...

    Karl - the adjuster you're talking about, how do I turn it?

    Tommy - I can turn it by hand with the wheel off just fine.

    As I'm trying to pull it...
  23. Replies
    3,158
    Views
    541,559

    I need to remove a very stubborn brake drum... I...

    I need to remove a very stubborn brake drum... I know this sounds noobish, but I've taken these things off plenty of times. Usually a good hammer whack or prying with some screwdrivers will do the...
  24. Replies
    3,158
    Views
    541,559

    they are the same on each side? one looks longer...

    they are the same on each side? one looks longer than the other...
  25. Replies
    3,158
    Views
    541,559

    I forgot to measure my axles when I took them out...

    I forgot to measure my axles when I took them out and rebuilt them, anybody know how long the rear axle shafts are on a 79 bronco?
Results 1 to 25 of 91
Page 1 of 4 1 2 3 4