repairs or beer. It's okay to spend the emergency fund on beer
(hey you, yeah you with the logic over there, what are you doing here? Get out!)
Type: Posts; User: uglyota
repairs or beer. It's okay to spend the emergency fund on beer
(hey you, yeah you with the logic over there, what are you doing here? Get out!)
what's orange and looks good on a ford? :D
^^^nice! don't give out my flywheel/pressure plate resurfacing recipe!
check rockauto for those rotors and drums...good prices on chinese clap
I know jack shiat about ford transmissions, and nearly so about auto transmissions in general. I bet you could google it though. I would get the shift kit.
you could pull the pan and manually free each of the little balls then replace pan and refill, or even see if you could ream out each of the holes and put bigger balls in it, or you could do a shift...
something about that picture has always struck me as "not quite right"
dude looks more like a tweaking hog farmer than a hippie.
I hate hippies! all they do is smoke pot and smell bad!
he has a long wheel base, it'll be fine
sparling for your rear axle on that truck I'd go welded/spooled or find and swap in an axle with an LSD.
:)
Since it sounds like you're fully prepared to beat this thing into an unrecognizable wad, maybe put some trick shift in it? Oughta make those bands a little stickier
I don't get the "won't rev over 2k" part...this isn't a drive by wire... Maybe something like a weak alternator combined with a bad coil or ecm just barely getting the voltage it needs to run, and...
And I bet if you spent a few days working on it you could even figure out a hack to get the points' coordinates without buying the pro version! :)
well I'll be darned...soneone's already done it!...
that's a really dam good job with sketchup. Did you start with a series of control points or something? Does sketchup let you export to dxf?