$1500, needs some work. But damnit its a running Jeep with a V8 and A/C!
Type: Posts; User: JB
$1500, needs some work. But damnit its a running Jeep with a V8 and A/C!
12/17 per fueleconomy.gov
I don't know. I would assume it gets less than 14.
Paying rent for two places and trying to buy house. Jeep needs to go. $1600
For now, it seems to be working fine, but I won't be surprised if it is dead in a couple days.
The Jeep works very well. It runs 70mph down the road just fine and is impressive for a stock non...
55 was at idle, A/C running.
$1800 for Hotpocket. Ready to wheel and plethora of aftermarkt bolt ons. Do it!
winna winna
new starter and it runs.
The alternator is only putting out 55. I think I will need to replace it soon.
Going to do motor mounts today or tomorrow.
If they were, it wouldn't be very mysterious now would it.:flipoff2:
It already has spacers
I should have some more info when I mess with it today.
Also, does anyone know where on Jeeps the coolant level sensor might be? It is mysterioulsy losing water, but even after I fill it up it...
The Jeep has some electrical issue. I swapped out an old Walmart battery, and put in a freshly charged one. It ran for a couple days, little errands around town. Parked it for a couple days and it...
Everything looked good except for the clutches and the TC, which had muddy water in it. I really never got it that deep at Spring Creek. That one crossing was maybe mid door, but it has a had...
He is putting clutches in it and we will see how long it lasts.
"pile full of clutches in your pan" was the quote from Kevin at Trans Specialties :D
I haven't lost total interest, but Bronco is back in the driveway awaiting motor. I would sell it for the right price.
correction. I think it shifts into second, but not to third. I do not think it is something internal, but I left it at the trans shop for them to check out.
Some carpet has also been removed.
Transmission won't shift out of 1rst now, but it will do 50 in 1rst.
Got the new trackbar on. While working under there, I realized my money wouldhave probably been better spent on motor mounts.
All the pics I took yesterday turned out super lame. We went out to 47 and played around for a while. The Jeep did very well, only getting hung up on the t-case skid a few times. I thought the...
The interior door panels are all back on. The passenger side door exterior plastic went back on after some "body work" and looks good.
I finished it up today. Ditched the rear sway bar and left the front disconnected. I drove it to NAPA and it was a a little squirelly, so I reconnected the front. The rear should come up another...
Next mods are either a rear locker, good t-case skid, or front bumper. That is if the front end stays together.... If I was DD'ing it, it would need a track bar, steering stabilizer, tre's,...
I got the front done. I am not a big fan of coil spring compressors. I got some cheap muds and mounted them on the rims I got from Colman. The center caps on my truck wheels fit, so I am going to...
Debating on the cheap spacer/shock lift or Rustys basic 3". It is hard to not spend money on this thing with the plethora of bolt on parts. It could use a bumper, sliders, t-case skid, etc.
I...