Where is the best place to get aftermarket exhaust systems for side by sides? My 2012 Ranger Crew 800 has a cracked manifold and all of the spring and everything are rusted out. Muffler is shot too....
Type: Posts; User: Shaggy
Where is the best place to get aftermarket exhaust systems for side by sides? My 2012 Ranger Crew 800 has a cracked manifold and all of the spring and everything are rusted out. Muffler is shot too....
Your unit bearing shouldn't allow it to move like that. You sure it is tight in there?
I found a couple other sites. I guess 9.99 shipping isn't terrible. I just hate spending a lot on shipping on a cheap part.
Any other website? They want $21.22 shipping ground for a $20 part.
thanks
The Aussie locker in the front dana30 in Jason's jeep is making a lot of noise. I took a look at it and it is engaging and disengaging much too easy. I want to replaced the springs in it. I think...
Mine is a 91' didn't notice the year range
My 60 is out of a 4 door
I have a 33gallon tank you can have that is just in my way. It has however been repaired once upon a time with the gas tank repair crap. Never had a problem with it after using it.
I disconnected my driver airbag when going full hydro. Just spun the wheel till the wire broke.
Walmart cheapo lights. Work decent too
I use ps fluid you can buy it by the gallon at several parts stores
Hand held blows farm animals. I will never go back. Get a 40$ hard mount one from walmart and call it good.
9/16 I think. And you should be able to do it with an extention. Deep not required.
For some reason that doesn't work. It clears it but 15 seconds later it Pops back up
Blow me
I changed the oil in the dodge and need to turn off the oil light. Any of you dodge owners have your owners manual and can check how to turn it off? I forgot.
Thanks
Tate
Theirs doesn't come out until 6/15.
I want to put a cold air intake on the dodge. Anybody have any recomendations?
Tj linkage went backwards. I used the yj and it goes the right way. Just doesn't have enough throw to go all the way back
It is different. I had him send me his linkage. It still doesn't line up.
Don't know if they Are high or low but I can tell if both outputs are engaged or not. I will pull the speedo sensor and see if anything weird fell in there in transit and is acewing things up
This is busa's case. Came out of his and bolted into mine. The only thing I installed in it was the speedo sensor. I don't see how that could cause any problems
What is the shift pattern on a tera-low case? Standard case is 2h-4h-n-4l. I have shifted through this case over and over again and I get 4-4-n. That is with no 2 at all and possible 4h and 4l on...
And this hobby isn't?