Search:

Text me at 210-396-224zero

91 bronco
351w, zf5, bw1356
D44 ttb w/ auburn limited slip, rear 9 inch with disk brakes and a Detroit locker
Mastercraft seats, 92 front clip, tube rear bumper
37" Toyo MTs mounted on 17"...

+1 for what Sharpe said, I use Milton qc fittings. You also might look to see what pressure your compressor is regulated at and bump it up some. I've run my impact at some pretty high pressures at my...

That's a 6.4 powerstroke. Timing is gear driven on a majority of modern diesels. This is the result of bad tuning, either written with too much timing or someone put a giant tuner on and just beat...

It definitely looks like 2 valves got a little intimate with the piston.

Pretty much needs a whole motor. Cheap way out would be to sleeve this one cylinder, and replace all the pistons. I'm not sure what that would do for longevity. I'm glad it's not my truck

http://uploads.tapatalk-cdn.com/20161107/150853644ae2d4b047b449d3b6f3da39.jpg

What kind

Trade you my bronco

We're here to drink beer but it turns out that if you do it at home by yourself and snapchat pictures of your wet bar at home that makes you an alcoholic.

List looks good, I'd make sure the...

8.8 swap FTW. We put one in taylors grand cherokee and it's been flawless. Stock disk brakes are a huge plus

It was 2wd so I had to play with a handicap

In with bronco leaving Thursday if I don't sell it.

Pretty sure my suburban went up the RTI ramp that far.

I normally wouldn't vote that route on a classic Mustang but this one has that dash, that steering wheel and that front suspension. At this point **** it. They make swap mounts and exhaust and...

I'm with travis, efi needs to go, and just put a carb on it. Spend the money on heads instead. I have a set of twisted wedge heads NIB with 170cc intake runners, assembled with screw in rocker studs...

#lsswaptheworld

You don't want to spend money on aluminum heads, which have tons of benefits over cast iron, but you're going to spend 1k on aftermarket efi so it might start a little easier, and might drive a...

Nvm, saw the dash. Disregard previous questions.

Forget money, gt40 heads are a waste of time. Are you really going to slap some junk yard heads on there with no work because they were cheap? You know al heads come with valves ready to bolt on...

Idk what custom aluminum dash means, but the screen isn't very aesthetically pleasing. If you don't mind the screen and you know what you can do for a speedo (didn't read to see if you can integrate...

Good luck, I hear those things are pretty sweet.

Gt40p heads are ancient, why no aluminum heads? 400 hp is a lofty number when talking about stock ford cast iron heads. I have JBs 69 351 heads machined for screw in rocker studs and full roller...

Roadkill used MSD atomic efi on a build that looked pretty simple. If you're going for a pretty stock motor, I don't really think you can go wrong with any of the aftermarket kits.

So what are your plans for this one? A big tip/stack, and windshield banners look like the needed components to finish the bro kit. Does it have a smoke switch?