Any paint that's on good enough for a pressure washer to not remove is on good enough to paint over. Just sand it a little.
Type: Posts; User: eight
Any paint that's on good enough for a pressure washer to not remove is on good enough to paint over. Just sand it a little.
Do not put hub caps on. Good to feel how hot the hubs are when you stop. Also when a bearing goes out the grease cap will fall off first, easier to notice when there's no cap.
Don't get a ranch hand, they kind of suck. Don't fit lines of truck so well, powdercoat will rust after a couple years, not real clean workmanship. Overall just a little ****ty.
These are good...
All you kids will eventually figure out that fullsizes suck for serious offroad rigs. Sure JB's bronco has always done well, but the parts in it would work so much better in a smaller rig. I think...
They make these things called YJs. One ton axles bolt in, atlas or stack bolts in, it comes with a 190hp fuel injected motor, it does not have lots of body or glass to worry about, if you get tired...
You're gonna break some **** with solid mounts and flexy frame.
That's pretty much what I did. Works.
You could also look at 39.5" TSLs, they run small.
You may be able to chunk the misalignment bushings to get some more clearance. Just bolt it on without them and turn the wheels to see if it hits. A tie rod doesn't get much misalignment. I'm not...
Too little pressure will let the wheel hit the rock through the tire, causing the tire to be no good. With his driving style I wouldn't go much lower. I only run 6-8 in the jeep and it's a fair...
It takes some power to run the solenoid. Sometimes the wire through the column and all drops too much voltage to power the solenoid. So you just use that wire to power a relay that powers the...
Is that a complete new custom knuckle? Or some sort of modified stock?
That'll look badass with 35s.
No it can't be the booster.
If your master cylinder does not have enough volume then you might think about going to the one ton, if it has a bigger bore. With the stock one on my jeep the pedal...
I use grade 8 bolts and a little grinding to the heads.
Its thinner. And you'll have a hard time finding a fine thread nut anyway. Check with Ace bolt and screw, they ordered a bunch of the 3/4" when I needed some. Order some misalignment washers too. ...
http://www.jegs.com/cgi-bin/ncommerce3/ProductDisplay?prrfnbr=91923&prmenbr=361