The TJ stands for Tate Jeep Buildup

**Shaggy** · 10-16-2008, 05:07 PM

Originally Posted by Fredo

First time I've checked this thread in awhile. I don't know why mine would be a good fit for a TJ...the ears would be way too low unless you stepped them up at the ends. I'll take a straight on shot for you when I get home...after I go pick up the ****pile camaro from the body shop.

thanks... i think I saw it in a pic the other day but wasnt really paying attention to it

**Fredo** · 10-16-2008, 07:20 PM

Here you go...let me know if you need a shot from any other angle.

**DRAGOONRANCH** · 10-16-2008, 11:36 PM

Originally Posted by Fredo

Here you go...let me know if you need a shot from any other angle.

We need one with you on the hood. And wear that speedo I got ya for your b-day...

**Shaggy** · 10-20-2008, 04:09 PM

ok the Aussie locker is loud... I think it is because the pinion seal in the axle leaks so bad (refer to barb-wire pic earlier in this thread)... i don't know if I will have time to replace it before this weekend so I guess I am gonna keep pumping gear oil into the thing

**Shaggy** · 10-20-2008, 04:10 PM

I got a used spare tire that is the same size and also ordered some KM2's... hope they come in before the weekend

**AggieTJ2007** · 10-20-2008, 06:13 PM

the aussie locker will quiet down after a short time, heavier gear oil helps too. You will really enjoy its performance

**Seth** · 10-20-2008, 07:20 PM

just put in thicker oil, the cure too all life's problems!

**Shaggy** · 10-20-2008, 07:53 PM

85x140 is in it already

**Seth** · 10-20-2008, 10:17 PM

w?

**DRAGOONRANCH** · 10-21-2008, 05:15 AM

just squeeze a tube or two of grease in there.

**Shaggy** · 10-21-2008, 07:05 AM

Originally Posted by Seth

w?

85w 140 gear oil... the thick stuff

**Shaggy** · 10-28-2008, 05:20 PM

well I got the oil pan dropped and surveyed the dammage... wasnt too bad. I tried to weld it up with the arc welder but it just burnt through. what rods should I use to keep it from burning though? or do I need to find someone with a mig

**uglyota** · 10-28-2008, 05:55 PM

eastwood company used to sell this deal that split your amperage in half for arc welding sheetmetal, if you're already using 1/16 rods turned all the way down maybe you should try that. Or a mig.

**robertf03** · 10-28-2008, 06:38 PM

if its 220, unplug one of the legs on the extension cord, i bet thats all the thing you are talking about did

**AggieTJ2007** · 10-28-2008, 08:30 PM

long arc your rod too it will help lower the amperage and heat

Thread: The TJ stands for Tate Jeep Buildup

Thread Tools

Rate This Thread

Display

Posting Permissions