Now back on track, anyone ever used 1A Auto?
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
What are the differences in 5.0 blocks in the 80's and 90's between cars and trucks? I'm going to pick up an engine to rebuild soon, just want to make sure everything will work with the speed density crap on the truck right now. Thought about an engine swap and I think I just want to go with rebuilt stock for now. My reason for a rebuild is because I'm getting some loud lifter tap that goes in and out, and it's over 200k, I just want to make sure I have something I can rely on.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
the holes drilled and tapped in the lifter valley for the spider are the only block difference.
...
I've always liked ranch hand, my grandpa has them on his super duty
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
frontier, they are a lighter than a ranch hand
Tommy Matheaus '06
210-323-2546
2004 F-140 4x4 DD
1990 F-150 4x4 in the works
1992 Jeep Cherokee basterdized
No ECO BOOST?!?! Did he not buy into the hype!??!
By the way the wife has the 5.0 in her mustang, it is a beast of a motor.
This ain't a bad look:
http://fabfours.com/Products/Ford/F1...PreRunnerGuard
Last edited by FJAggie07; 02-02-2011 at 06:10 PM.
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
"It's not cheating if you pay for it"
FabFours has a Black Steel line that is more budget friendly (less labor intensive to build).
http://fabfours.com/BLACKSTEEL/Ford/...ackSteelBumper
Not sure if they have them for 1/2 tons though.
The disco ball in my mouth, insinuates I'm ballin'