Huh? So you are saying bridging the channels, thus reducing resistance will cut your power output? Go re read your physics book.
Travis find out what the amp is stable at then wire you voice coils and amp to match. Wiring them in parallel will be have the ohms of one coil, in series will add the ohms together. Then run to the amp. Same thing goes for the amp outputs, bridged will reduce ohms at the amp. Too little resistance gives you a lot of bang but can over heat your amp.
ediit: Here is a better diagram.
Like it says, make sure the amp can handle a two ohm load when bridged. Some 2 channel amps dont like 2 ohms in bridged mode. If you wire it up this way and the amp goes into protect, you'll have to wire it at 4 ohm bridged.
Last edited by Hot Pocket; 05-07-2012 at 04:14 PM.
2010 VW Jetta - DD, 5 Banger, 5 Speed, 1000 Watts of sound!! 1979 Ford Bronco Custom - 400/T18/205.. 35" SSRs, 4" lift, Rancho 5000s, 200 watts of sound!!