stop in the ME shop and ask whoever runs that place now. they always had teflon "bar stock" laying around.
stop in the ME shop and ask whoever runs that place now. they always had teflon "bar stock" laying around.
Cutting board?
McMaster sells samples too
Originally Posted by Shaggy
FYI, you can replace Superduty ****ty vacuum hubs with early Ford/chevy dodge Dana 60/dana50 locking hubs. You will need to use the ford style outer c-clip that has multiple layers. The negative side is the set inside the hub cap by about an inch.
Last edited by stx4wheeler; 07-01-2010 at 08:58 AM.
He who dies with the most **** wins, after seeing your collection you are in the lead no doubt!
do you have to change the spindle nuts or are they unit bearing, like you have to do on 93-97 fords when you go from manual to auto locking hubs?
Creighton, you have done stuff with that jeep that would make a goat go "holy ****!"
You don't have to do anything they are unit bearings. It was literaly a 15 min swap.
He who dies with the most **** wins, after seeing your collection you are in the lead no doubt!
sweet that is good to know
Creighton, you have done stuff with that jeep that would make a goat go "holy ****!"
What's the price jump from 1 tons to rockwells?
Just scrap in now tommy.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
Clarke has a rear and I got a quote for 800 for a front from some 2 1/2 ton military truck place. IDK if that's market price or higher.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
Clarke is using it on his ranger. I want two fronts.
1600 for 2 fronts is what I was quoted. I can give you the email address if you want it.
http://houston.craigslist.org/pts/1819324846.html
Just found that
Last edited by Sparling; 07-02-2010 at 04:08 PM.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
red river supply use to have the best rockwell prices
I think this is them: http://www.redriverparts.com/
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
http://houston.craigslist.org/pts/1823012712.html
You should put this in your bronco since you're getting rocks.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
I dont even wanna know.... Rockwells are cheaper
Ryan Clarke
(214)695-7901
Clarke, i'm getting crazy ideas..........CRASY i tell you
Posting Permissions
Reply With Quote