Almost flush to out a little.
Almost flush to out a little.
On the 8th day god created the Super Swamper TSL and said "go forth and kick ass"
So when i bought my truck there were some wires from the heater under the dash that you would just twist together to make it work. There is a hole cut in my heater box and two wires come out. I have tried every combination of power and ground to these wires but it still doesn't come on. What did the p.o do? How do i make it work?
it used to work, now it doesn't
Last edited by TdmayfieldIV; 02-13-2010 at 09:25 PM.
define work, does the motor blow just not hot, does nothing happen, do you hear any noises electrical or not. we need more info
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
Did you check the fuses?
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
run a jumper wire to one from the hot side of the battery and ground the other. if that doesn't work do the opposite. if that still doesn't work then your motor is fried or maybe the resistor if you have one
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
So do you think the p.o just put new wires on the motor when the factory wiring stopped working? Whenever the motor was on it always blew hot.
sounds like its ben a victim of a a po's bad wiring. someone knowledgeable might have to take a loot at it
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
the red kind
Ryan Clarke
(214)695-7901
On that note, **** Ford for using 4 different incompatible ATFs in the last decade.
On the 8th day god created the Super Swamper TSL and said "go forth and kick ass"