So my search continues as I learn I can only fit a drive shaft from another auto 4 banger... I have been quoted for rebuilds at $300 (no way...) And one at $175 plus shipping...
Was also told that a drive shaft from a manual will not clear the auto tranny pan...
Any advice?
Thanks guys
Can you post what kind of vehicle it is you want the shaft for?
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
oh, I thought my sig would show up...
Sorry its a 99 Jeep Wrangler 2.5L auto...
SHUT UP AND WHEEL
There are two driveshaft shops in town if you need to have it repaired. Brazos Valley Drivelines and Bryan Drivetrain, either are about as good.
Boats and hoes
Stumble in to the liquor store
With a dollar-fifty for a bottle of wine,
I know just what I'm lookin for
Thunderbird will do just fine.
Boats and hoes
Stumble in to the liquor store
With a dollar-fifty for a bottle of wine,
I know just what I'm lookin for
Thunderbird will do just fine.
whats wrong with it and is it a front or rear that you need done. if it is the front you can make your own but on a street jeep get a rear made
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
I have used BVD a couple times with no problem.They are out on 2818 just past the Hall
92 YJ
04 F-150 4x4
11 F-250 4x4
I found a good one for 175 shipped, I think I'm going to jump on it?
I'm not exactly sure whats wrong with it... I'm still new to the 4x4 world... Something it broken in the center? Its at home in Houston so I can't really give a good description... Wish I could.
Its the front drive shaft, and I don't have the selectable hub so the front drive shaft is always spinning...
Last edited by breckboarder55; 09-23-2008 at 03:11 PM.
SHUT UP AND WHEEL
is that a new one or used, probably used. are you sure that is is good or did someone just have it laying around. you might be able to get yours rebuilt for that. where in houston is it. houston ds shops have been cheaper than up here from my experiences
Red 81 CJ5, 35's, 4.10 and detroit, 4 to 1 dana 300, tbi efi, flat belly, cage, chromos and auzzie in front... sometimes runs. body damage to come
If it's making a lot of noise you can spray lithium grease into the CV ball and see if that helps. If it does and the noise comes back you may be able to get away with having someone rebuild the CV and replace your u-joints.
Its just out side of the woodlands (north side)
The one that is 175 is from Davey Jeeps, so its used, but the guy has a good reputation from what I have heard and he says its good.
I don't mind spending a little bit more on that one and having it for this weekend...
I have been dieing to wheel my own rig...
SHUT UP AND WHEEL
Posting Permissions
Reply With Quote
