Finished pulling the front axle yesterday to do the gear swap. Found the heim joints on both lower control arms are pretty worn out. They are a 3/4" x 3/4" heim with a bushing to reduce the hole to 5/16" (I think it's actually metric...close enough ) The 3/4" heim seems a bit small for something like a control arm...yall think I should just pick up another 3/4" heim and run it or should I look into something like a bushing - http://www.ballisticfabrication.com/...ot_p_1646.html. I also found a guy that has a pair of RE lower control arms for 100 bucks...seems like not a bad deal. Thoughts?