for sale xjs whole or parts (perfect nubie rigs)

[junior88mj]

He doesn't get on too often, so I'll try to help.

The stock brackets are still there...the axle is currently bolted under his MJ. The high steer brings your drag link up higher on the knuckle. This is helpful with lifted jeeps because it will make your drag link angle more flat. This way you could avoid needing a drop pitman arm on a shorter lift and with a taller lift there would be less side to side movement of the axle which should reduce binding of the control arms at flex. I'm not sure if Jr did it yet, but you also have to relocate one end of the track bar...either raise the axle end or lower the frame end...to get your track bar parallel with the drag link again. Supposedly the WJ brakes will fit with 15" wheels, but only aftermarket wheels. The factory 15" wheels have too much offset.

What BDR said

[junior88mj]

You wouldn't have a set of decent xj spring sitting around would you?

yes $100 set

[breckboarder55]

5-5 bolt pattern iirc?

[mudtoy67]

No, he used his original unit bearings to keep the 5x4.5

[junior88mj]

bump

[colman]

i need to get that other xj main leaf from you and we need to meet up to get you those cj fenders and dash, what are you doing friday morning?

[breckboarder55]

You still have this D30?
(pictures if available)

[junior88mj]

yep still have it, it's still in my mj , i'll try to get some pics or you can come by and look i'm in bryan just give me a call 979-820-2252 next week thanks junior

[junior88mj]

bump

[breckboarder55]

Left you a voice mail about buying an HPD30.