just flip it over
looks like XXX tractions kit
Ryan Clarke
(214)695-7901
maybe its the angle but it looks like you arent penetrating as well on the lower plate, but like i said it could be the angle
Yeah, I'm working on it. I think the wire speed may be too low for me but I didn't want to mess with Travis' settings.
I would say its getting better, but like creighton said, you arent penetrating the bottom (insert joke)... And in my opinion you are running a little too cold
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
"It's not cheating if you pay for it"
I agree with Sam. See if that welder goes to 11.
"You know, this car is so fast, that giving Corvette owners this car, is kinda like giving an AK-47 to a pysch ward."
-Ron Fellows (Corvette C6R Team Driver)
Took me all day to do this.......how much is a cnc plasma table?
That's not strap, that's cut out of a piece of plate, that's why it took so long.
I probably could have gotten it done in a couple hours but I wanted them perfect so fitting and welding is easy.
Last edited by TdmayfieldIV; 06-25-2011 at 01:06 AM.
If you wait a month or so I might have a Plasma Cam table for sell
Ryan Clarke
(214)695-7901
a 4x8 torchmate plasma table was ~10k last I heard. I never did get to price one myself though.