Made me a steering stop.
Made me a steering stop.
Originally Posted by Sharpe
I've always been under the impression that with HA, the steering box will not keep putting pressure on the cylinder/ram when it maxes out side to side negating the need for steering stops. The orbitals in full hydro are another story.
My bitch better have my money...
Through rain, sleet, or snow...
My whore better have my money...
Not half, not some, but all my cash...
'Cause if she don't,
I'm gonna put my foot in her ass.
I thought the stops go inside the ram
Ryan Clarke
(214)695-7901
Ideally
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
so why couldn't one go inside this ram?
1976 F-100 Kustom Krawler
1976 F-150 Custom
1964 CJ5
It could, im sure it was done that way due to time constraints
Last edited by BroncoJo; 04-07-2012 at 10:39 AM.
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
Travis and I made up this bracket. It's really tight under there.
here's how psc says to mount it.
so you did the complete opposite?
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
"It's not cheating if you pay for it"
That uses diff cover bolts and my ram is bigger than that.
thats a 2011 truck! must be a bad bitch to need hydro assisthere's how psc says to mount it.
Or it could just be owned by one of your diesel douche friends
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
"It's not cheating if you pay for it"
first you need a longer bolt for the axle side mount
second, is the 'stop' secured in any way, so it cant slide up and down the shaft, if not i bet you will get a gouge in the shaft and then start leaking fluid
Stop will be secured
The mount is not perfect, but should work for TCC, and it will be called the "plate-30" ram kit.
Born to Kill
I just watched a spider dominate a fly on the wall outside, i thought would would travis do? and i did the opposite, spider lives!
any idea of how you are going to secure the stop?
also the mount doesnt look that bad, but you may need one of those ram skid plates like jb has/had
Posting Permissions
Reply With Quote