Anyone got any 5"x3"x1/4" angle need about a foot and 15"x6" of 3/16" plate? If nothing turns up I'll just go to mack bolt and steel but wanted to see if any members had some first. Thanks
Anyone got any 5"x3"x1/4" angle need about a foot and 15"x6" of 3/16" plate? If nothing turns up I'll just go to mack bolt and steel but wanted to see if any members had some first. Thanks
go to custom fab before you drive out to mack
Ryan Clarke
(214)695-7901
never mind, I have found it, next to brazos welding supply right?
custom fab is on 2818 near the industrial park in bryan. i dont recall how much cheaper the mill plate is at bryan iron but it was enough that i used it almost exclusively while i was in BCS.
and you have to buy full or half stick of materlial now too. I only use custom fabe now, they always have clean metal, cut what ever you need and can get DOM within a week. They are a little pricey then everyone else, but they always have what i need and i dont have to drive or deal with idiots
Ryan Clarke
(214)695-7901