You are referring the just the axle shaft, right? I would definitely find a used shaft and replace just that before I replaced the whole axle.
You are referring the just the axle shaft, right? I would definitely find a used shaft and replace just that before I replaced the whole axle.
if its a dana 35 i know where some shafts are in CS that you can have.
which side?... i have a pass side
Jonathan Tate
361.676.6466
2010 Dodge Ram 2500 4x4 6.7 MegaCab
2004 Jeep TJ
1992 Jeep YJ
2008 Jeep JKU
2013 Ford Explorer Sport (mama's go fast car)
They are the same. I have two spares for wheeling if you can't find any, but you should be able to find some for cheap.
3.07s are standard on NSG370 TJs, but 3.73s were an option... I would consider staying with 31"s if you have 3.07s...
Here are the homemade disconnects:
http://www.4x4xplor.com/homediscos.html
Been running with these for a while. $10 or so to make.
SHUT UP AND WHEEL
SHUT UP AND WHEEL
Needs more triangu.... oh, wrong thread
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat