Regeaing a dana 35

[breckboarder55]

I don't know if it's been mentioned, but the D44 is about an inch longer and has a different yoke. You'll need a sye, drive shaft, and adjustable control arms.

There are a couple decent write ups on Jeep Forums for the spring bucket relocation.
http://www.jeepforum.com/forum/f9/ou...cation-929056/

[crdub09]

I don't know if it's been mentioned, but the D44 is about an inch longer and has a different yoke. You'll need a sye, drive shaft, and adjustable control arms.

There are a couple decent write ups on Jeep Forums for the spring bucket relocation.
http://www.jeepforum.com/forum/f9/ou...cation-929056/

Ive already got an sye with a woody shaft, plus adjustable control arms and a new yoke, so that wont be a problem. I'm currently wrestling with making a dana 44 carrier fit into a rubicon d44 differential.

As for the spring buckets, I grinded off the stock buckets last night and am looking for perferably bolt on solutions for new coil buckets but I'm not getting any luck with a TJ coil setup.

Btw-- did you get my message about selling me the left knuckle on your old dana 30?

[breckboarder55]

Ive already got an sye with a woody shaft, plus adjustable control arms and a new yoke, so that wont be a problem. I'm currently wrestling with making a dana 44 carrier fit into a rubicon d44 differential.

As for the spring buckets, I grinded off the stock buckets last night and am looking for perferably bolt on solutions for new coil buckets but I'm not getting any luck with a TJ coil setup.

Btw-- did you get my message about selling me the left knuckle on your old dana 30?

Yeah, I messaged you back.

Bolt on spring perches:
https://secure.aev-conversions.com/s...ode=NTH23030AA

You should really use weld on buckets IMO.