Looks good, are you going to put air bags in it for towing?
No. It has one ton leafs not deavers. It shouldn't squat much. My other truck didn't squat at all hauling a carhauler with something on it.
The Toyos need a good scrubbing and they will look much better.
Last edited by Sparling; 03-20-2013 at 04:47 PM.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
I might find brackets for the bags I have. It won't be a Carli long travel kit that's for sure.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
*** needing bags to haul anything on a car hauler
92 YJ
04 F-150 4x4
11 F-250 4x4
Travis's dodge did. My truck didn't
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
you still haven't installed those?
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
My passenger side axle shaft is hanging down and hitting the lower ball joint. This is with a brand new Moog hub. What do I need to check?
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
U-joint in the axle shaft???
-Karl
2006 Chevy K3500 4X4 - No J.B. Weld on it yet!
1982 thru 94 F-Series "The Klogger" AKA Transport on the road, on the trail, or on the trailer!
1965 Chevelle
1975 Corvette
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat
u need the seal on the shaft. if u dont pull the unit bearing out real straight the metal piece in there gets bowed out. if your truck has auto lock hubs they are not going to work with the seal hanging out.
or yur missing the snap ring, if there is one, I can't remember
Manual hub so I'm not worried about the seal unless the seal holds the axle shaft up somehow. I'll recheck the snap ring. I also might get a new axle shaft joint because the one on there looks pretty worn out.
'91 Bronco 351w, ZF5, D44 TTB, 9" rear swap with disk brakes, 37" toyos, method wheels, mastercraft seats, A/C and heat