Results 1 to 3 of 3

Thread: Toyota Spring Hanger Question for Toyota Guys

  1. 03-10-2003, 04:04 PM #1
    Chadnutz
    Chadnutz is offline
    TAMOR Obsession Chadnutz's Avatar
    Join Date
    Apr 2002
    Location
    San Antonio
    Posts
    2,617
    Send a message via AIM to Chadnutz

    Toyota Spring Hanger Question for Toyota Guys

    Did you guys buy .25" thick strips to make your spring hanger or what? The springs are about 2.75" wide, so should I make the part that has the holes for the bolt out of .25" strip or buy some 3" square/rectangle/channel and just have .125" play on each side?

    Use 2x2 square tubing for the piece that connects the two sides?
    Reply With Quote Reply With Quote
  2. 03-10-2003, 06:56 PM #2
    Jackasic
    Jackasic is offline
    VW Ninja Jackasic's Avatar
    Join Date
    Apr 2002
    Location
    Jackasicstan
    Posts
    3,643
    Send a message via Yahoo to Jackasic
    psss, all the Toyota guys are out of town on vacation.
    www.monergism.com
    Reply With Quote Reply With Quote
  3. 03-10-2003, 07:33 PM #3
    Chadnutz
    Chadnutz is offline
    TAMOR Obsession Chadnutz's Avatar
    Join Date
    Apr 2002
    Location
    San Antonio
    Posts
    2,617
    Send a message via AIM to Chadnutz
    I figured it out anyway. I'm going to buy the metal tomorrow and then stay after work to sand blast some stuff. I can't wait to get the seal kit so I can put the axle back together and be done with that. Then I just have to order bushings and a tie rod and drag link. Fixing to go pick up calipers tonight.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules