It's a little short, but I think it might work...
I busted a u-joint pulling into a driveway a week or so and it decided to lodge the stub shaft's ears partially into the inner shaft's ears, thus squeezing the stubs ears in a little bit. I know this is ghetto, but is there any way that I can bend the ears out a little bit (safely) and keep it connected to the inner shaft as another spare. All my damned spares have 260 joints and it'd be nice to keep this 297 set. It's not bent that much, but I don't know if this is a smart idea.
Here's a pic. It doesn't show much, but for a reference I can get one clip in and the other needs about 2mm.