i traded my coilovers for some old goodyears
i think they are taller than james's 42s
the transfer case came in so i went ahead and bolted it up to the tranny. they make a good pair.
i traded my coilovers for some old goodyears
i think they are taller than james's 42s
the transfer case came in so i went ahead and bolted it up to the tranny. they make a good pair.
nice choice on the H2 rims. Can't go wrong with them for as cheap as they have been going...not to mention they look sweet without the centercap.
"You know, this car is so fast, that giving Corvette owners this car, is kinda like giving an AK-47 to a pysch ward."
-Ron Fellows (Corvette C6R Team Driver)
So clayton in december right.........no excuses
i hope so.
lookin good. Whens the engine going in?
Scott, FTAC '99
'62 Nissan Patrol 4-seat Twisted Customs Buggy
'89 "CJ-7" - Her trail rig
'05 Toyota Tacoma 4x4 TRD - her daily driver...
'08 Dodge 2500 Mega Cab 6.7 Diesel 4x4
scott.schubring@williams.com
The office sucks - I wanna go wheeling!
waiting on my motor mount to come in and the motor should be in the first of next week.
by time i make a mount its cheaper to just buy one.
updates?
Scott, FTAC '99
'62 Nissan Patrol 4-seat Twisted Customs Buggy
'89 "CJ-7" - Her trail rig
'05 Toyota Tacoma 4x4 TRD - her daily driver...
'08 Dodge 2500 Mega Cab 6.7 Diesel 4x4
scott.schubring@williams.com
The office sucks - I wanna go wheeling!
don't have time to take pics, but i will try later today.
cage is almost finished
made tie rod 1 5/8 O.D. X 13/16 I.D. drill and taped for 1" 16 thread for TRE.
dash is made but holes are not cut for gauges
the detriot is in the rear and welded the front.
motor is mounted and belly pan is made.
and other things.
a few pics
nope its just for trail only
I like the belly pan. How thick is it? did you weld nuts into the frame? riv-nuts? or what. Have you thought about countersinking the bolts and using countersunk allen heads. then grease that thing up like a fifth wheel!
grayson those are factory skid plate holes
...
i will probably just use button head bolts, the plate is 1/4''
were i to do one, id just cut squares out of plate thicker than the bolt head with holes in the middle big enough for a socket to fit in. weld them to the skid plate then taper the edges off with a grinder.