actually, when I put in the crossover bar, I made it removable so it would be easier to install a hood and work on the engine, so I can get it out of the way. The biggest 2 problems are the stainless steel lines that stick up for the propane system, and that ugly ass master cylinder I have. Both will require somewhat wierd cuts to make a hood fit. I actually went out there and measure everuthing when I got home a few minutes ago, and I'm thinking of just getting someone to cut me a few pieces of steel sheet to match. The roof should be relatively easy, the hood is gonna take some work. What thickness would every suggest for this? I want to keep it as light as possible, but it needs to be thick enough that it doesn't flex or bow (it has to cover around a 2 foot span unsupported). I hope I can find the time to get this done next week