O2 sensor weld in nuts

[fbronco86]

I know you can order them online. But has anyone found them at a autoparts store or anyplace of that nature?

[agjohn02]

got mine from hedman.

look in kopecki's "jeep mods round 2" thread. he's got some polish way to do it.

[agjohn02]

nevermind i found it for ya

Useful information you may never need to know: An O2 sensor screws into a d44 ball joint nut, and the ERG banjo fittings on a SBAMC are 9/16" fine thread.

[robertf03]

try an exhaust shop

[fbronco86]

try an exhaust shop

I tried that and everyone in WT lufkin still uses carbs.

edit Its a 18mm thread I dont think a dana 44 has a 18mm thread on it

[uglyota]

I think a FJ80 does though. Lufkin got a toyota dealer?

[fbronco86]

I think a FJ80 does though. Lufkin got a toyota dealer?

Yeah I am not that far in the sticks. I have some good vendors at work for bolts and nuts. I will give them a call.

[73bronco]

Rusty muffler in Bryan has them

[Fredo]

lufkin must suck. Everytime I've needed one, my exhaust guy just gives them to me. He's made enough off of refferals much less the business from my family alone to give a couple of o2 bungs away.

[agjohn02]

I tried that and everyone in WT lufkin still uses carbs.

edit Its a 18mm thread I dont think a dana 44 has a 18mm thread on it

i know, thats whats so polish about it. i tried it and it does in fact screw all the way in, AMAZING. almost like its the right size.

[spool]

Go to the motormite section of you autoparts store and get the anti fouler plug for ford then cut them off. They are the same thread as o2 sensors and you get 2 for 5 bucks

[fbronco86]

lufkin must suck. Everytime I've needed one, my exhaust guy just gives them to me. He's made enough off of refferals much less the business from my family alone to give a couple of o2 bungs away.

Yes it does kinda suck. I did find some for 5 bucks.